User Manual

90
o
Verify tail belt is not twisted
then rotate 90 degrees
COUNTER-CLOCKWISE and
install onto tail shaft pulley.
IMPORTANT: Tail belt should only have
ONE 90 degree twist. Verify tail rotor
rotates counter-clockwise when viewed
from the right, while the main rotor
rotates clockwise when viewed from
above.
Apply BLUE threadlocker where
indicated.
101-308
M3x8 Button Head
108-613
6x13x5 Radial Bearing
101-306
M3x6 Button Head
516-409
Vert Tail Fin
516-404
Tail Box Plate Left
106-601
6mm Shim
01 | INTRODUCTION
02 | FRAME
03 | LANDING GEAR
04 | BELT TENSION ARM
05 | MAIN DRIVE
06 | BOOM INSTALLATION
07 | TAIL ASSEMBLY
08 | SETTING BELT TENSION
09 | SWASH PLATE
10 | CYCLIC SERVOS
11 | ANTI-ROTATION GUIDE
12 | TAIL SERVO
13 | MAIN HEAD
14 | PITCH LINKAGES
15 | MOTOR INSTALLATION
16 | BATTERY TRAY & CANOPY
17 | BLADE INSTALLATION
18 | COMPLETE MODEL
07 | TAIL ASSEMBLY
22
Rev 1.0M
TAIL - BELT AND LEFT SIDE