User Manual

Feed tail belt around the main
drive pulley at this stage of the
build.
MAIN SHAFT ORIENTATION: The hole
nearest the end of the shaft is the top.
Position indicated shim below main
drive unit and then insert the M3x25
Shouldered Bolt.
IMPORTANT: Do not overtighten!
TIP: Use a 5.5mm nut driver when
securing the M3 bolt.
For low head speed setups (2,300 rpm
or less), Synergy offers an optional tail
pulley to increase tail rotor rpm. See
page 21 for tail rotor rpm setup.
IMPORTANT: Combined main and
tail blade length should not exceed
603MM.
Example configurations:
Rail 516 Mains + Rail 80.6 Tails =
596.6mm.
520 Mains + Rail 80.6 Tails = 600.6mm.
Blade Size Considerations:
109-111
10x12x0.25mm Main Shaft Shim
516-413
Tail Belt
516-104
Main Shaft
8.0mm
11.5mm
100-351
M3 Nylock Nut
100-325A
M3x25 Shouldered Bolt
01 | INTRODUCTION
02 | FRAME
03 | LANDING GEAR
04 | BELT TENSION ARM
05 | MAIN DRIVE
06 | BOOM INSTALLATION
07 | TAIL ASSEMBLY
08 | SETTING BELT TENSION
09 | SWASH PLATE
10 | CYCLIC SERVOS
11 | ANTI-ROTATION GUIDE
12 | TAIL SERVO
13 | MAIN HEAD
14 | PITCH LINKAGES
15 | MOTOR INSTALLATION
16 | BATTERY TRAY & CANOPY
17 | BLADE INSTALLATION
18 | COMPLETE MODEL
05 | MAIN DRIVE
17
Rev 1.0M
MAIN DRIVE INSTALLATION