User's Manual

SYNCOMM Proprietary
2
2.Explication of operation
(1). Firstly, setup the environment as figure 1-1.
(2). Run Hyper Terminal, setup it and prepare for monitor RP’s
state. (Please refer the third item for how to setup hyper
terminal)
(3). Setup the parameter of RP. (Please refer the fourth item for
setup various parameter in RP)
3.Explication of how to setup Hyper Terminal)
Step 1: Run Hyper terminal
Figure 3-1 the path for executing Hyper Terminal
After ran the Hyper Terminal you could see the status as below.
If you couldn’t find Hyper Terminal, you must re-install it
Hyper Terminal