User's Manual

ManualsBrandsSyncomm Technology ManualsElectronicsRADIO PORT

SYNCOMM Proprietary

SYNCOMM Radio Port operation manual

1.Environment

Radio Port

Antenna

RS232 Cable: one set

Power module or Power supply: one set

PC or Notebook: one set

Power

Module

Antenna

Wire RS-232

Figure 1-1 Connection view of operation environment

Attention issues:

(1). Please make sure the antennas are connected with

Radio port before power on

(2). If no power module, you could use power supply

Summary of content (8 pages)

PAGE 1
SYNCOMM Proprietary SYNCOMM Radio Port operation manual 1.Environment Radio Port Antenna RS232 Cable: one set Power module or Power supply: one set PC or Notebook: one set Antenna Wire RS-232 RP PC Power Module Figure 1-1 Connection view of operation environment Attention issues: (1). Please make sure the antennas are connected with Radio port before power on (2).
PAGE 2
SYNCOMM Proprietary 2.Explication of operation (1). Firstly, setup the environment as figure 1-1. (2). Run Hyper Terminal, setup it and prepare for monitor RP’s state. (Please refer the third item for how to setup hyper terminal) (3). Setup the parameter of RP. (Please refer the fourth item for setup various parameter in RP) 3.
PAGE 3
SYNCOMM Proprietary Figure 3-2 the screen after ran Hyper Terminal Step 2: Setting connection port In figure 3-2,select “file”, select “content”, then get the screen as below Set the port that you connect PC and RP use RS232 Figure 3-3 Select connection port Step3: Port setting 3
PAGE 4
SYNCOMM Proprietary Set the data transfer rate (bits/second), bits per unit, parity check, stop bits, data flow control as below. Figure 3-4 Hyper Terminal port setting 4.Various parameter setting After we done all the preceding action, we turn on the power of RP and watch the windows of Hyper Terminal (1).
PAGE 5
SYNCOMM Proprietary (2). Enter main menu (3).
PAGE 6
SYNCOMM Proprietary (4). Input 2 to enter RF test menu (5).
PAGE 7
SYNCOMM Proprietary (6). If you Select 3, you can set the output power of transmitter, the range from 0 to 255, mapping to output power level from 0 to 800 mW, you can use this way to setting output power level to correct output power level. (7). Select 4, you can set the operation frequency of transmitter, range from 0 to 599, mapping to 1.93 GHz to 1.
PAGE 8
SYNCOMM Proprietary 8