Install Instructions

SYNCOMM Proprietary

Assemble the two combined entities (left and right) from Step1 with

component (2) by M6*20 screws with grommet or spring grommet

between the screw and screw nut using components (6), (8), (9),

and (10). Then press component (14) into component (3).

Step3:

Fix the rack from Step1 and Step2 on the pole by two stainless bands,

component (5), respectively on the op and the bottom following the instruction

in Figure 5-3.

Step4:

Screw two antenna sets (component (11) and component (13) ) onto the two

sides of component (3) tightly with antenna facing the outer side.

Step 5:

Fix the radio port (component (1)) on the rack by M6*20 screws with

grommet or spring grommet between the screw and screw nut

using components (6), (8), (9), and (10), and the installation is

complete.

Step 6:

According to figure 5-4, connect ANT0, ANT1, LINE cable, and the EARTH

cable to the RP.