Use and Care Guide

①
①
②
②
③
③
①
①
②
②
③
③
[When Arm unit is only fixed] [When remote control stand is fixed]
※
※When remote control stand is fixed in right hand side
Connect the Arm unit hose (gray/black/yellow) matching with color of whole hose.
Screw the Arm unit.
The remote control stand is also screwed together during remote control stand
fixation. When screwing them as follow.
①anteroinferior→②anterosuperior→③posterosuperioe
●Remote control stand is usually fixed in left hand side.
●Press the arm unit firmly toward to the frame and screw it.
● The following operation is carried out only when remote control stand is fixed in right hand side.
This operation is not necessary if the remote control stand is fixed in left hand side.
(1) Remove the base part screw of remote control stand.
(2) The remote control stand is bent towards right and the screw is
fixed in left screw hole.
(1) Remove the Screw.
※Enlarged image of remote
control stand base part
(Top view image)
(2) The stand is bent towards right
and screw is fixed by matching the
right side dent to the left screw hole.
If the torsion is
severe, it is
removed once
and fixed again
so that the
torsion severity
is less
Gray
Remote
control
stand
Remote
control
stand
Yellow
Black
※Tighten the
screws lightly at
first and
retighten the
screws firmly by
the hex wrench
of accessory.
①Match the groove of hose from arm
unit and projection of hose from main
body, then insert it along the groove.
②Lock the both
parts while pushing.
Projection
Groove
Arm unit side
Main body side
※Turn the
both parts
firmly till
the end.
13