Deciding the setup place of who'e unit \ /Y DANGER || /1. WARNING | Use the chair on a level surface. Do not use outdoors. Damage or accidents may occur. Do not use or store in the bathrooms or places Do not close to stoves or other sources of fire, of high humidity or moisture. Electrification, fire, | | hor smoke whilst using the chair. Do not use on accidents, and molding may occur. heated carpets or other heating equipment. Do not operate under blanks or pillow.
Continuation (Setup and assembling) Raising the backrest part Raise the backrest part in arrow mark direction and check that it is fixed in stopper (O part) position. (Generates clinking noise) @ When moving the backrest part, hand or finger should not be inserted in between seat and back rest position. ® And care should be taken in such a way that remote control cord and power cord doesn’t get held between seat and back rest position.
2. Connect the Arm unit hose (gray/black/yellow) matching with color of whole hose. (D Match the groove of hose from arm unit and projection of hose from main body, then insert it along the groove. @Lock the both parts while pushing. i R «— disunion wry ¥ If the torsion is severe, removed once and fixed again Black At e FIE H Tum the .torsion severity g my pars is loss & the end 3. Screw the Arm unit. The remote control stand is also screwed together during remote control stand fixation.
Continuation (Setup and assembling) Herder Gt [Fixing of left armrest] 1. (1) Front side of left arm rest is matched with frame. (2) Arm unit is matched to back side by lifting it. % The am unit should surely be lighted when matching it with the whole unit, Failure to do so, then the arm unit will be in contact which may lead to damage. ¥ Caster part fixing image 2. Firmly screw with armrest screw.
[Fixing of right armrest]] 1 . (1)The back side of right armrest should be matched with power switch BOX. (2) Arm unit is matched to back side by raising it. ¥The arm unit should surely be lifted when matching it with the whole unit. Failure to do so then the arm unit will be in contact and may lead to damage. ¥ Power switch BOX fixing image Cover the right armrest with caster and power switch Right Armrest Power switch BOX r\ Power Cord %Power cord should be fixed correctly so that it could exiting a gap f
Continuation (Setup and assembling) 3. Fixing the Cap (Right/Left direction) 3% Aim the marking part and match the o Cap for fixing each hole is decided. with the cap side » Check the surface symbol of cap and fix it. o When the cap is raised to the surface, check as there are possibilities of insertion mistakes. [For Left side] Nixing the Remote control [Fixing method] Remote control should be inserted from the top. t [Removing method] Remote control should be pulled out from the top. .
Attach the back pad and plow 1. Attach the back pad in order of numbers. 2. Pillow should be attached the surface fastener of back rest part it ha Pillow Surface fastener o When massage is performed, attach the back pad and rotate the pillow to the back side. + When massage is felt as hard, attach the pillow and use it. » When massage is not done, attach the back pad and pillow as such and use it as a reclining chair. Grounding insinuations 1. DANGER || 1\ WARNING \ Ground should be installed firmly.
Before starting massage every time Check around the chair Check the surroundings without fail ® Check to make sure that there is nobody, no pet and nothing ahead behind the chair and under the footrest. DANGER \ Do not use the chair other than on the designated voltage. Fire or electrification may occur. Inge rt the power plug filmy so that no dust is accumulated. Failed to do so may cause electric shock, short circuit, or ignition. Do not use damaged power plug or power cord.
