User's Manual

4. Thenodeappearstohavestoppedsendingonthenetwork(Doesnot
applytoRemoteGateway2)
Checkfortheflashingredlight(above)toseeifthenodehas
somehowfallenoutofthenetwork.

Thenodecanberesetwithouttheremovalofthebattery
comportmentbythe
useofamagneticresettool,orany
mediumpoweredmagnet.Whilewatchingthediagnosticlight
area,movethemagnetalongthelongedgeoppositethe
externalsensorports.Thediagnosticlightswilllightandflash
whenthenodehassuccessfullyreset.

5. TheRedLEDisflashingonRemote
Gateway2:
Thisindicatesthenodeisoperatinginbatterybackupmode.
Thisiscausedbylossof5VDCpowersuppliedtotheDCJack
connector.Checktheexternalwalladapterispluggedinand
haspower.

6. LossofNetworkcommunication:
CyclepowertoRemoteGateway2byturning
theon/offswitch
toOFFposition(markedOonfrontpanel),wait10seconds,and
thentoONposition(markedIonfrontpanel).