User's Manual

Subfloor EZ Node Hardware Installation Guide
Version 1.0
10
General Installation Guidelines
Ensure software installation and required file exports are complete before installing hardware.
Be consistent and neat.
 Match all node installations in appearance to ensure optimum data collection
 Ensure there are no hard turns or kinks in hoses during routing and installation
 Ensure each node provides a representative pressure measurement of the surrounding area
 Clean installation surfaces thoroughly with alcohol wipes and allow area to dry
 Ensure no tripping or other data center wiring hazards result from Subfloor EZ Node installation
 Adhere to safety regulations
 Inform customer when relocating nodes to ensure compliance with site safety protocols
Use cable ties and adhesive cable clips as needed.
 Attach cable ties such that the locking mechanism is always on the inside
 Use diagonal cutters to clip cable tie ends close to its locking mechanism
 When external low-pressure hoses are requested, use adhesive cable clips to ensure appropriate
air pressure measurements
Installation Process Flow
Figure 1 shows the installation process flow for installing Subfloor EZ Node.
Figure 1 – Subfloor EZ Node Installation Process Flow