User's Manual
Table Of Contents
SynapSense Intelligent Gateway Installation Guide
December 17, 2013
19
4. Insert Gateway Mounting Shelf on screws. Insert screwdriver through front mounting holes and
tighten screws to secure shelf to surface.
5. Connect the Power Adapter to the Gateway and the designated power outlet.
6. Connect the designated Ethernet Cable (originating from a server port assigned by the data
center's IT department) to the Gateway.
The Radio Activity LED will remain OFF
The Unit Status LED will blink RED continuously when the unit is ON.
7. Insert the Gateway’s mounting spacers in the shelf’s front mounting holes and slide the Gateway
downward to bottom of mounting hole slots.
8. Secure and route Power Adapter wire and Ethernet Cable using adhesive Cable Clips.