User Manual

Table Of Contents

Model SM240 Data Sheet · Document Number 430154-01A · Page 9 of 12

2.0 Agency Certifications

2.1 United States (FCC)

The Model SM240 modules comply with Part 15 of the FCC rules and regulations.

Compliance with the labeling requirements, FCC notices and antenna usage guidelines

is required. In order to comply with FCC Certification requirements, the Original

Equipment Manufacturer (OEM) must fulfill the following requirements.

1. The system integrator must place an exterior label on the outside of the final

product housing the SM240 Modules. Figure 2.1 below shows the contents that

must be included in this label.

2. SM240 Modules may only be used with the antenna that has been tested and

approved for use with the module. Please refer to the antenna table provided in

this section.

2.1.1 OEM Labeling Requirements

NOTICE:

The OEM must make sure that FCC labeling requirements are met. This

includes a clearly visible exterior label on the outside of the final product housing that

displays the contents shown in Figure 2.1 below.

Figure 2.1 FCC Label

2.1.2 FCC Notices

WARNING: The SM240 modules have been tested by the FCC for use with other

products without further certification (as per FCC Section 2.1091). Changes or

modifications to this device not expressly approved by Synapse Wireless Inc. could void

the user’s authority to operate the equipment.

MANUFACTURERS NAME

BRAND NAME or TRADE NAME

Contains SM240 FCC ID: U9O-SM240

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interferences, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.