User Manual

DRAFT COPY
Generated on
9/16/2014
16
SNAP Engine SM220 Series Data Sheet — 430000-01A
NOTE: The OEM can choose to implement a single label combined for both FCC and IC
labeling requirements. If a combined single label is chosen, there must be a clearly visible label
on the outside of the final product housing displaying the contents shown in Figure 8 below.
MANUFACTURERSNAME
BRANDNAMEor TRADENAME
Contains SM220 FCC ID: U9O-SM220
Contains SM220 IC: 7084A-SM220
This device complies with Part 15 of the FCCRules. Operation is subject to the following two
conditions:(1) This device may not cause harmful interferences, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Figure 8: Combined FCCand IC Label
OEM Labeling Requirements for the European Union
The “CE” mark must be placed on the OEM product in a visible location. The CE mark will consist of
the Initials “CE” with the following form:
If the CE marking is reduced or enlarged, the proportions given in the following
drawing must be adhered too.
The CE mark must be a minimum of 5mm in height.
The CE marking must be affixed visibly, legibly, and indelibly.
Since the 2400-2483.5 MHz band is not harmonized by a few countries
throughout Europe, the Restriction sign must be placed to the right of the
CE marking as shown in the drawing.
NOTE: The OEM can choose to implement a single label combined for FCC, CE and IC labeling
requirements. If a combined single label is chosen, there must be a clearly visible label on the
outside of the final product housing displaying the contents shown in Figure 9 .