User's Manual

2.0 Agency Certifications
2.1 United States (FCC)
The RF Engine nodules comply with Part 15 of the FCC rules and regulations.
Compliance with the labeling requirements, FCC notices and antenna usage guidelines is
required. In order to comply with FCC Certification requirements, the Original Equipment
Manufacturer (OEM) must fulfill the following requirements.
1. The system integrator must place an exterior label on the outside of the final product
housing the RF Engine Modules. Figure 1 below shows the contents that must be
included in this label.
2. RF Engine Modules may only be used with antennas that have been tested and
approved for use with the module. Please refer to the antenna tables provided in this
section.
2.1.1 OEM Labeling Requirements
WARNING: The OEM must make sure that FCC labeling requirements are met.
This includes a clearly visible exterior label on the outside of the final product
housing that displays the contents shown in Figure 2-1 below.
Figure 2-1. FCC Label
* The FCC ID for the RF Engine without external amplifier is “U9O-RFE”. The
FCC ID for the RF Engine with external amplifier is “U9O-RFET”
MANUFACTURERS NAME
BRAND NAME or TRADE NAME
Contains RF Engine FCC ID: U9O-RFE*
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interferences, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.