User Manual

RF300PD1 Data Sheet Document Number 430135-01A Page 11 of 13
2.1.3 FCC Approved Antennas
The RF300 modules are FCC-approved for fixed base station and mobile applications.
The FCC requirement for mobile applications states that the antenna must be mounted
at least 20 cm (8 in) from nearby persons.
Notice: To reduce potential radio interference to other users, the antenna type and its
gain should be chosen so that the equivalent isotropically radiated power (e.i.r.p.) is not
more than that permitted for successful communication. This module has been
designed to operate with the antennas listed below in Table 2.1. The required antenna
impedance is 50 ohms.
Table 2.1. Approved Antennas
Part Number Type Gain Application Min.
Separation
Linx ANT-916-CW-RCL Dipole (quarter-wave RPSMA) 0.47 dBi Fixed/Mobile 20 cm.
Recommended Antenna: