User Manual

RF26X Data Sheet Document Number 430141-01A Page 9 of 14
Host Board Example RF26X Mounted
Picture 1.1 RF26X Mounted To Host Board
2.0 Agency Certifications
2.1 United States (FCC)
The Model RF26X modules comply with Part 15 of the FCC rules and regulations.
Compliance with the labeling requirements, FCC notices and antenna usage guidelines
is required. In order to comply with FCC Certification requirements, the Original
Equipment Manufacturer (OEM) must fulfill the following requirements.
1. The system integrator must place an exterior label on the outside of the final
product housing the RF26X Modules. Figure 2.1 below shows the contents that
must be included in this label.
2. RF26X Modules may only be used with the antenna that has been tested and
approved for use with the module. Please refer to the antenna table provided in
this section.
2.1.1 OEM Labeling Requirements
NOTICE: The OEM must make sure that FCC labeling requirements are met. This
includes a clearly visible exterior label on the outside of the final product housing that
displays the contents shown in Figure 2.1 below.