User Manual

Table Of Contents

Model RF200A Data Sheet · Document Number 430133-01D · Page 11 of 15

1. The system integrator must place an exterior label on the outside of the final

product housing the RF200A Modules. Figure 2.1 below shows the contents that

must be included in this label.

2. RF200A Modules may only be used with the antenna that has been tested and

approved for use with the module. Please refer to the antenna table provided in

this section.

2.1.1 OEM Labeling Requirements

NOTICE:

The OEM must make sure that FCC labeling requirements are met. This

includes a clearly visible exterior label on the outside of the final product housing that

displays the contents shown in Figure 2.1 below.

Figure 2.1 FCC Label

2.1.2 FCC Notices

WARNING: The RF200A modules have been tested by the FCC for use with other

products without further certification (as per FCC Section 2.1091). Changes or

modifications to this device not expressly approved by Synapse Wireless Inc. could void

the user’s authority to operate the equipment.

NOTICE: OEM’s must certify final end product to comply with unintentional radiators

(FCC Section 15.107 and 15.109) before declaring compliance of their final product to

Part 15 of the FCC Rules.

NOTICE: The RF200A modules have been certified for remote and base radio

applications. If the module will be used for portable applications, the device must

undergo SAR testing.

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

MANUFACTURERS NAME

BRAND NAME or TRADE NAME

Contains RF200A FCC ID: U9O-RF200A

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interferences, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.