User's Manual

Page 6 of 14 RF Engine 200 Series Data Sheet — 430133-01C
Symbol Parameter Condition Min Typical Max Unit
R
AS
Source impedance at
input
4
3k kΩ
RES Conversion Resolution
Single Ended CLKADC <= 4MHz 10
Bits
Single Ended CLKADC > 8MHz 8
DNL Differential non-linearity V
REFH
= 1.6V CLKADC=4MHz -0.5 LSB
INL Integral non-linearity V
REFH
= 1.6V CLKADC=4MHz 0.8 LSB
E
ZS
Zero-scale error 1.5 LSB
E
G
Gain error 1 LSB
Table 1.5: ADC Timing/Performance Characteristics
Mechanical Drawings
These drawings in Figure 1.2 show the module with the RPSMA connector for use with an external
antenna, and the keep out area for the F-antenna.
NOTE: The area under the module's antenna (marked NOCOPPER or
KEEPOUTAREA)should have no components, no traces, and no copper on any layer of
the printed circuit board.
4 Any analog source with a source impedance greater the 3kΩ will increase the sampling time.