Certification Exhibit FCC ID: U9O-HCTAG01 FCC Rule Part: 15.249 ACS Project Number: 14-2059 Manufacturer: Synapse Wireless, Inc. Model: HCTAG01 User Manual 3998 FAU Blvd.
DATA SHEET HCTAG Series Model Number: HCTAG01 Part Numbers: HCTAG-ST201 Document Revision v1.1 © 2013 Synapse, All Rights Reserved All Synapse products are patented or patent pending Specifications are subject to change without notice – confirm that data is current Synapse, the Synapse logo, SNAP, and Portal are all registered trademarks of Synapse Wireless, Inc.
Page 2 of 7 Document Number 430157-01A · ©2013 Synapse Wireless, Inc. · 500 Discovery Drive, Huntsville, AL 35806 HCTAG Data Sheet · · 256-852-7888 · synapse-wireless.
Table of Contents 1. HCTAG01 OEM Device Overview ........................................................................................ 4 Specifications .............................................................................................................................. 5 Electrical Characteristics ............................................................................................................ 5 2. Agency Certifications ................................................................
1. HCTAG01 OEM Device Overview The HCTAG01 device is an IEEE 802.15.4, low-power, highly-reliable solution to embedded wireless control and monitoring network needs that require high data rates. The HCTAG01 embeds Synapse’s SNAP OS, the industry’s first Internet-enabled, wireless mesh network operating system into the Atmel ATMEGA1284RFR2-ZU singlechip AVR® microcontroller with an integrated transceiver that delivers up to 2Mbits/sec.
Figure 1.0 Block diagram showing the major subsystems comprising the HCTAG01 Specifications Table 1.0 HCTAG01 Specifications Transmit Power Output RF Data Rate Receiver Sensitivity Supply Voltage Transmit Current (Typ@3.0V) Idle/Receive Current (Typ@3.0V) Power-down Current (Typ@3.0V) Frequency Spreading Method Modulation Dimensions Operating Temperature Antenna Option Topology Error Handling Number of Channels UARTS with HW Flow Control FCC Part 15.
WARNING: The HCTAG01 modules have been tested by the FCC for use with other products without further certification (as per FCC Section 2.1091). Changes or modifications to this device not expressly approved by Synapse Wireless Inc. could void the user’s authority to operate the equipment. The HCTAG01 modules comply with Part 15 of the FCC rules and regulations. Compliance with the labeling requirements, FCC notices and antenna usage guidelines is required.
“This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment is in direct contact with the body of the user under normal operating conditions. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.” HCTAG01 Data Sheet ©2014 Synapse Wireless, Inc. · · Document Number 430157-01A 6723 Odyssey Dr., Huntsville, AL 35806 · 877-982-7888 · · Page 7 of 7 synapse-wireless.
