User's Manual

Step 9: Attach RFID Interface Module to Filler Neck Ring cable and RFID Extension

Cable and zip tie in place.

Step 10: From the mounting location of the AIM2 Main Module, pull the slack from the

RFID Extension Cable so that it is snug.

Step 11: Tighten all zip ties and clip the extra plastic with a pair of wire snips and seal

both drilled holes with silicon.

Step 12: Coil any leftover slack from the RFID Extension Cable secure so it is out of the

way.

Step 13: Connect OBD interface cable (KSM-DEV052305, KSM-2538 or KSM-2539) to

the Vehicle’s OBD connector and AIM2 Main Module via the OBD Port (Fig. 1) and

secure cable so that it is out of the driver’s way.

Step 14: Start vehicle, AIM2 Main Module status lights should turn on.