User's Manual

23
Mount & Connect the TIM
o Mount the TIM within close proximity of the pre-determined Vehicle Charging
Cradle mount location. The TIM must be within 20 feet of the Vehicle Charging
Cradle.
o Using the mounting bracket as a template, drill four holes into the desired surface
location. (Some applications will use self-tapping screws, so pre-drilling will not be
necessary). Using the provided hardware, install the bracket and slide the TIM into
the bracket.
o Assemble antenna kit (part # 981A0200) and install the assembly to the pre-
determined antenna mount location.
o Connect the antenna threaded coaxial connector to the threaded coaxial connector
on the TIM. Note: It is strongly recommended that the TIM coaxial connector be prevented from
turning while fastening the antenna cable connector. Damage to TIM internal connections can occur
if TIM connector is allowed to turn while attempting this connection.
o Insert the cable bundle connector (part # 032C0344) into the Main connector port
on the TIM (see Figure 1) ensuring that the latching mechanism locks the two
connectors securely.
Install & Connect sensors and cabling
o Fasten the green ground leads of the Temp-Pulse/Interface or barrier cable (part #
981D0114) to a chassis ground and connect to TIM cable assembly (part #
032C0344).
o Install Pulser to flow meter register.
o Install Temperature sensor or Temperature probe (see Figure 16 &17) to plenum or
prescribed location.
o Connect pulser sensor cable (part #981D0117), and temperature compensation
sensor cable (part # 981D0118/032E0107) to TIM cable assembly (part
#032C0344).
o Wire the TIM 12 Volt DC Power cable (part # 981D0105) to an external power
source and connect to TIM cable assembly (part #032C0344).
o Gather any excessive slack in cabling and secure in a neat manner using cable
ties, wire loom, etc. Be sure to allow for cable tension relief during installation.
Mount & Connect the Vehicle Charging Cradle
o Mount the Vehicle Charging Cradle in a location that is within 20 feet of the TIM.
o Connect the Charger and Data Bus Cable (part # 032C0346) from the TIM cable
bundle to the Vehicle Charging Cradle.
o Connect the ADC Printer (part # 032C343) cable to the back of the Vehicle
Charging Cradle and into the ADC Printer (if so equipped).