Specifications

PAGE 4 OF 8
OPERATING INSTRUCTIONS
Using the Control Panel: (Locate in Figure 3 & Figure 4)
Figure 3
A. POWERB. FLAME
D. TIMER
C. HEATER
F. DOW N
E. UP
Main Switch (Figure 3.A):
✦
The POWER button supplies power to all the features of the fireplace. This button must be ON for any of
the features to work properly.
✦
Once turn ON, digital area shows room temperature, activates the flame and amber light flickering.
✦
Once turn OFF, all current settings will be stored and then restored at the next power ON (except Timing
Control). Unplug the unit will reset the setting to factory default.
Simulated Flame Effect (Figure 3.B):
✦
Press once to active the highest simulated flame effect.
✦
Press second time to active the second highest simulated flame effect, and so on.
✦
There are 5 flame options :
1. Amber Flame, digital area shows “A”.
2. Midnight Flame, digital area shows “M”.
3. Polar Flame, digital area shows “P”
4. Flame off, only log light, digital area shows “H”.
5. Violet Flame, digital area shows “U”.
✦
Press Turn up or Turn down to adjust the flame brightness, not including Gradient flame. There are 5
levels. No action after 15s digital area shows room temperature, and 5s later shows blank.
1. 5th level--highly bright, digital area shows “5”
2. 4th level--fully bright, digital area shows “4”
3. 3th level--medium bright, digital area shows “3”
4. 2th level--low bright, digital area shows “2”
5. 1th level--slight bright, digital area shows “1”
✦ In shutdown mode, press the Flame button for 6 seconds to turn on or turn off the beep sound.
✦
These features can also be controlled with the Remote (Refer to Page 6).
G. DISPLAY SCREEN
PRODUCT#ZHS-23-N