Installation & Assembly

10
Remote control requires one 3V CR2025 Lithium Cell Battery (included and pre-installed).
Remove the protective sheet between the battery and the contacts
in order to operate (see Fig 1. and Fig.2).
REPLACE THE REMOTE CONTROL BATTERY
When the remote-control stops operating, or its range seems reduced. It is time to replace the battery with a new
one.
1. The battery compartment is located on the back end of the remote.
2. Press and slide the battery door open and remove the old battery.
3. Insert a CR2025 battery, checking that the “+” and “-” terminals of the battery matches the inside of the
battery compartment.
4. Replace the battery compartment door.
NEVER dispose of batteries in fire. Failure to observe this precaution may result in an explosion.
Dispose of batteries at your local hazardous material processing center.
CARE AND MAINTENANCE
Cleaning
NEVER immerse in water or spray with water. Doing so could result in electric
shock, fire, or personal injury.
Metal:
ALWAYS turn the heater OFF and unplug the power cord from the outlet before
cleaning, performing maintenance, or moving this fireplace. Failure to do so could result in
electric shock, fire, or personal injury.