Installation & Assembly

-3-

WIRED CHIME INSTALLATION

IMPORTANT: Proper installation requires a diode on the front

door push button. See Diode Installation Instructions (page 5)

after completing steps 1 through 9 below.

Note: Electrical work must be in accordance with national and local

electrical codes. If in doubt, consult a qualiﬁed electrician.

Note: DO NOT install batteries if connecting chime to transformer

wires.

2. Remove cover from existing chime.

3. Label all wires before disconnecting. Using masking tape, mark

each wire according to existing chime terminal markings (see

Chime System Wiring Diagram, page 14).

• “F” – Front Push Button Wire

• “T” – Transformer Wire

• “R” – Rear Push Button Wire*

4. Disconnect all wires from existing chime.

5. Remove existing chime base from wall.

Figure 1

Volume Control

Tune Selection

Button

Sync / Reset

Button

Mounting

Holes (x4)

Transformer

and Push

Button Wire

Connections

Continued

Wire

Entrance

Hole

Battery

Compartment

SYNC – PRESS

AND RELEASE.

RESET – HOLD

10 SECONDS.

TUNE – HOLD

1 SECOND.

FRONT TRANSREAR

1. Verify transformer power rating. Power must be supplied from

a 16 Volt AC, 10 Watt or a 16 Volt AC, 15 Watt transformer