Installation & Assembly

-2-
This chime unit is designed to work with:
• Wired push buttons (see Wired Chime Installation, page 3)
• Wireless push buttons (see Wireless Chime Installation, page 6)
• Combination of both wired and wireless push buttons (see Wired
Chime Installation, page 3)
Package Contents
• Multi-Tune Wireless and Wired Combination Base
• Chime Cover
• Mounting Hardware
Items needed for installation (not included):
• Phillips and flathead screwdrivers
• Safety glasses • Drill • 7/32" (5.5 mm) Drill Bit
Illustrations may vary from actual chime unit.
SYNC – PRESS
AND RELEASE.
RESET – HOLD
10 SECONDS.
C
H
I
M
E
V
O
L
U
M
E
TUNE – HOLD
1 SECOND.
UP
FRONT TRANSREAR
For Wired Installations For Wireless Installations
• 16 Volt AC, 10 Watt or a 16 Volt
AC, 15 Watt Transformer
• 3 “C” Alkaline Batteries (when
used as a wireless chime only)
• Wire strippers/cutters
• Pliers
• Masking Tape
• Marker
Questions or problems?
REMOVING CHIME COVER
Firmly pull on cover to remove it from chime base. Note: Never use
cleaners or polishes. Never use any fluids on the electronic chime
mechanism. Use dry cloth to clean chime cover and base.
*This wireless push button may be added to a wired system.
Before returning to your retailer, refer to the troubleshooting guide
in this manual. If the problem persists, call our technical service
department (English speaking only).
• Wired Push Button(s)* • Wireless Push Button(s)