Owner Manual

Installaon
Step 1 (Fig. 1)
Determine desired mounng locaon on a wall or an eave.
Step 2 (Fig. 2)
Unlock the locking switch (D).
Step 3 (Fig. 3)
Remove mounng plate (C) from xture by turning plate clockwise.
Step 4 (Fig. 4)
Remove the exisng light xture and install the mounng bracket (H) with the stamped word
“FRONT” facing away from the juncon box.Use the mounng bracket screw (L) to x the
mounng bracket. Firmly pull on the mounng bracket to verify it is securely mounted to the
juncon box.
Step 5 (Fig. 5)
Use connector (I) to complete wiring, and use ground connecon screw (M) to connect ground
wire with mounng bracket (H).
Step 6 (Fig. 6)
Use M5 screw (J) to link the mounng plate (C) with mounng bracket (H), the screw should not
be xed too ght.
Step 7 (Fig. 6)
Adjust the mounng plate (C) to make sure the air bubble in air level is in the middle. Link the M4
screw (K) on mounng bracket (H). Tighten M4 screw (K) and M5 screw (J).
Step 8 (Fig. 7)
Align the boom edge of the power supply compartment (B) with the boom edge of the
mounng plate (C). Insert the conducng post on power supply compartment (B) into the holes
on mounng plate (C). Tilt and lock the locking switch (D).
CAUTION: Read how-to secon before turning power back on at circuit breaker or fuse.
Fig. 3
Fig. 1
Fig. 4 Fig. 5
Fig. 2
Fig. 6