Installation Sheet

Caution: If replacing an older faucet ensure water supply
is turned OFF before removing. en open faucet valves to
relieve water pressure.
Step 1 Attach control valves to sink
■ read ange nut down 2
inches from threaded end
of valve body.
■ Insert valve body from
underneath sink through
mounting hole. Ensure
valve with red striped
hose (hot) is on le and
blue (cold) is on right.
■ Place gasket over valve
body and thread fastener
onto valve body until
stop is reached.
■ Tighten ange nut and mounting washer under sink and
secure with mounting screws if necessary.
■ read collar over outer threads of
fastener until tightened against surface of the sink.
Step 2 Attach faucet handles
■ Turn valve spindles to
the OFF position.
HOT - le valve,
clockwise
COLD - right valve,
counter clockwise
■ Attach handle to
valve spindle in OFF
location as shown.
■ Fasten to spindle with
Phillips head screw
and insert plug button.
Step 3 Attach faucet spout to sink
■ Unscrew tee and
remove washer
and nut from
threaded end of
spout as shipped.
■ Insert end of spout
down through
mounting hole in
sink and then fasten
from under sink
with washer and nut.
■ Tighten nut while
ensuring spout is
centered over mounting hole and
at edge of washer is facing rear of sink.
Step 4 Connect water supply lines
■ Apply pipe sealant on both ex hose adapters. read into
sides of tee.
■ read center of
tee onto end of
spout.
Note: is may
require about
4 inches of
clearance to
rotate.
■ Attach ex hoses
to ex hose
adapters.
■ Plumb hot water
supply to le
valve inlet, cold
water to right
inlet (supply
hoses not included).
■ Check for leaks if only replacing faucet and drain is already
installed by rst turning faucet handles to the OFF position
and then turn water supply valves ON.
Step 5 Fasten drain body to sink
■ Remove stopper, unscrew ange and remove at rubber
washer from end of drain
body as shipped.
■ Apply plumber’s putty
around bottom of ange.
■ Move friction washer,
beveled washer and
ange nut down away
from threaded end
of drain body.
■ Place ange in drain
opening and under sink
screw drain body up into
ange at least 2-3 turns
until hand tight. Apply
putty or teon tape to tail
piece and attach to drain
body.
■ Position drain body so
pivot cavity is facing
rear of sink and then
slide beveled washer and
friction washer up against sink.
■ Tighten ange nut up against friction washer to evenly
compress beveled washer while also ensuring ange
is centered in drain opening.
Take care not to over tighten ange nut.
Pipe
Sealant
ex hose
spout
valve
outlet
& inlet
ex hose
adapter
tee
valve
body
collar
fastener
gasket
valve body
mounting washer
ange nut
mounting screws
plug button
screw
handle
valve spindle
spout
washer
nut
tee
PLUMBERS
PUTTY
ange
beveled
washer
friction
washer
pivot
cavity
ange nut
drain body
tail piece
Installation Instructions
Page 2
Installation Instructions
Page 2