Installation Guide

Step 3 Connect water supply lines
■ read tee onto
end of spout.
Note: is may
require 4 inches
of clearance.
■ Apply pipe
sealant on both
ex hose adapters
and thread into
side of tee.
■ Attach ex hoses
to ex hose
adapters.
■ Plumb hot
water supply to
le valve body
inlet, cold water
to right inlet
(supply hoses not included).
■ Check for leaks if only replacing faucet and drain is already
installed by rst turning faucet handles to the OFF position
and then turn water supply valves ON.
Step 4 Fasten drain body to sink
■ Remove stopper, unscrew ange and remove at rubber
washer from end
of drain body as shipped.
■ Apply plumber’s putty
around bottom of ange.
■ Move friction washer,
beveled washer and
ange nut down away
from end of drain body.
■ Place ange into drain
opening and from under
sink screw drain body
into ange at least 2-3
turns until hand tight.
Apply putty or teon tape
to tail piece and attach to
drain body.
■ Position drain body so
pivot cavity is facing rear of
sink and then slide beveled
washer and friction washer
up against sink.
■ Tighten ange nut up
against friction washer to
evenly compress beveled washer while also ensuring ange is
centered in drain opening.
Take care not to over tighten ange nut.
Caution: If replacing an older faucet ensure water supply is
turned OFF before removing. en turn both faucet handles to
the ON position to relieve water pressure.
Step 1 Attach control valves to sink
■ read ange nut
down about 2 inches
from threaded end
of valve body.
■ Insert valve body
from underneath
sink up through
mounting hole.
Ensure valve with
red label (hot) is
on the le and blue
(cold) is on the right.
■ Place gasket over valve
body and thread
fastener onto valve
body until fastener
is secured tightly to
valve body.
■ Ensure spindle
is rotated to the
OFF position.
Fasten handle to top
of spindle located
in OFF position as
shown in illustration.
■ Press plug button into
top of handle.
■ Tighten ange nut
and mounting washer under sink and secure with mounting
screws if necessary.
Step 2 Attach center spout to sink
■ Unscrew tee and
remove washer and
nut from threaded
end of spout as
typically shipped.
■ Insert through
mounting hole
in sink and then
fasten from under
sink with washer
and nut.
■ Tighten nut while
ensuring spout
is centered over
mounting hole and
at edge of washer is
facing rear of sink.
Installation Instructions
fastener
gasket
mounting washer
ange nut
mounting screws
valve body
hot = cw
cold = ccw
spindle OFF
plug button
screw
handle
spout
washer
nut
tee
Pipe
Sealant
ex hose
spout
valve
body
valve
outlet
& inlet
ex hose
adapter
tee
PLUMBERS
PUTTY
ange
beveled
washer
friction
washer
pivot
cavity
ange nut
drain body
tail piece
Installation Instructions
Page 2