Installation Sheet

RC-14
SC-15
SC-13/18
SC-12A
SC-12D
SC-12
SC-7
SC-17
SC-26
SC-2
SC-19
C-5
SC-10/11
SC-20A/21
SC-10A
C-32-11
SC-3
C-32B-11
SC-9
SC-126 TO BE DISCARDED BEFORE INST ALLING TRIM
SC-125
SC-102
INDIVIDUAL PARTS COMPOSITE PARTS
C-5 Flow control spindle
C-32-11 Spindle assembly
C-32B-11 Plaster shield
RC-14 Lever handle
SC-2 Cap
SC-3 Renewable seat
SC-7 Packing nut with o-rings
SC-9 Cold washer retainer
SC-10A Hot washer screw
SC-10/11 Hot and cold washers
SC-12 Escutcheon and screw
SC-12A Escutcheon screw
SC-12D Escutcheon screw
SC-13/18 Dome cover and lock nut
SC-15 Handle screw
SC-17 Packing
SC-19 Cap gasket
SC-20A/21 Top seat o-ring & bottom
seat gasket
SC-26 Limit stop with o-ring
SC-102 Dial
SC-125 Escutcheon Gasket
SC-126 Plaster shield
Washer & Gasket KIT-B
SC-9 Cold washer retainer
SC-10A Hot washer screw
SC-10/11 Hot and cold washers
SC-15 Handle screw
SC-17 Packing
SC-19 Cap gasket
Repair units
SC-3 Renewable seat unit complete
C-50 Renewable seat socket wrench
C-5 Spindle
FIBERGLASS WALL
INSTALLATION
When installing Safetymix in fiberglass or
panel walls and it is desired to sandwich
wall between valve body and escutcheon,
cut hole in wall as shown in Figure 4 and
mount valve from rear. Note: It is always
recommended to secure valve piping to
rough construction and not depend on
fiberglass wall for valve mounting security.
On panel walls over 1” thick, install in
conventional manner. (See figure 1).
OPERATION OF VALVE
The main handle of the Safetymix valve
is for control of temperature only. From
the OFF position, the handle is turned
counter-clockwise through a minimum
cold position, through a warm and hot
position for a maximum turn of approxi-
mately one revolution. This allows for
infinite temperature adjustments to suit
the requirements of any user.
CARE AND CLEANING
The lustrous finish on your Safetymix
valve should be treated with care. It
can be readily damaged by improper
handling or abusive treatment. To clean
the finish wipe gently with a soft damp
cloth and blot dry with a soft towel. Use
only a mild soap solution if required. DO
NOT USE ABRASIVE CLEANERS. USE
OF POLISH, ABRASIVE CLEANERS,
SOLVENTS OR ACID CLEANERS WILL
DAMAGE THE FINISH AND VOID THE
SYMMONS WARRANTY.