Installation Guide

6
1) Remove slide bar ends from slide bar flanges. Using
flanges as a guide, drill 1/8" pilot holes into studs or
wood blocking. With slide bar in position, secure to
wall using screws. Attach slide bar ends to bar flanges
(FIGURE 11.1).
2) Remove screw cap from slide mechanism (FIGURE 11.2).
6) Press tabs on wall elbow flange. Install wall elbow to
pipe fitting. Turn clockwise to secure (FIGURE 11.6).
7) Attach small end of hand shower hose to wall elbow.
Turn clockwise to tighten (FIGURE 11.7).
3
FIGURE 11.1
1
2
4
11. Installation - Slide Bar Assembly
8) Attach large end of hand shower hose to hand shower
wand. Turn clockwise to tighten (FIGURE 11.8).
FIGURE 11.2
FIGURE 11.3
FIGURE 11.4
5) Install slide mechanism components to slide bar
following STEPS 11.2 - 11.4 in reverse. Flat edge on (N1)
and (N2) must be aligned. Arrows on (N1) and (N3)
identify bottom side (FIGURE 11.5).
Note:
Adjust screw cap for ease of movement of slide
assembly.
1
FIGURE 11.6
2
FIGURE 11.7
FIGURE 11.8
FIGURE 11.5
SLIDE
SLIDE
LOCK
N1
N2
N3
3) Remove wand holder from slide mechanism
(FIGURE 11.3).
4) Remove lever handle from slide mechanism
(FIGURE 11.4).