Install Instructions

 
STEP 3 – CONNECTING THE WATER SUPPLY

Fit the flexible pipe coming from the
faucet to the solenoid valve housing.
IMPORTANT: Inlet and outlet should
follow the indicating arrow in the
solenoid housing
NOTE: Make sure that the lter
is assembled between the
housing of the solenoid valve
and the inlet nipple.

The faucet is provided with an inlet
nipple, if needed, t the water supply
inlet to the adapter at the solenoid
valve housing.

Turn on the central water supply and
the shut-o valve (angle valve) and
check for leaks.
INSTALLATION
INSTALLATION
STEP 1 - REMOVE ALL MOUNTING HARDWARE
Shut o water supply and remove the
hexagonal nut, the disk and the gasket. Do
not remove the o-ring from the base of the
faucet.
O-ring
Gasket
Disk
Hexagonal nut
STEP 2 – INSTALLING THE FAUCET

Optional: Remove spacer, place
deck plate through the holes on the
deck and secure deck plate prior to
faucet installation.

Place the faucet with the o-ring into
the hole in deck or lavatory. Make
sure the o-ring is located between
the deck or lavatory and the bottom
of the faucet.
O-ring
Center
hole
size of the hole:
 mm / .”.”

Under the deck, slide the gasket,
disk and hexagonal nut over the
flexible hose and secure the faucet
into place.
Gasket
O-ring
Hexagonal nut
Washer
STEP 4 – CONNECTING THE POWER SOURCE

Remove the protective sticker from the
sensor

Connect the waterproof connector
coming from the electronic unit to
the solenoid valve connector.
FROM THE ELECTRONIC UNIT TO THE SOLENOID VALVE