Installation Guide

Installation Instructions
Page 2
Caution: If replacing an older faucet ensure water supply
is turned OFF before removing. en open faucet valves to
relieve water pressure.
Step 1 Attach control valves to sink
■ read ange nut about
2 inches down away
from end of valve body.
■ Insert valve body from
under sink up through
mounting hole.
Ensure valve with
red striped hose (hot)
is on the le and blue
(cold) is on the right.
■ Place gasket over valve
body and then thread
fastener onto valve body
down to about 3/4 inch.
■ read collar onto valve body until stop is reached and
then thread fastener back up against collar until hand tight.
■ Tighten ange nut and mounting washer under sink and
secure with mounting screws if necessary.
Step 2 Attach faucet handles
■ Turn valve spindles
to the OFF position.
HOT - le valve,
clockwise
COLD - right valve,
counter clockwise
■ Attach handle to
valve spindle in OFF
location as shown
and fasten with
Phillips head screw.
Step 3 Attach faucet spout to sink
■ Unscrew tee and remove
washer and nut from
threaded end of
spout as shipped.
■ Insert end of spout
down through
mounting hole in
sink and then fasten
from under sink
with washer and nut.
■ Tighten nut while
ensuring spout
is centered over
mounting hole and
at edge of washer is facing rear of sink.
collar
fastener
gasket
valve body
mounting washer
ange nut
mounting screws
screw
handle
valve spindle
spout
washer
nut
tee
Step 4 Connect water supply lines
■ read tee onto end of spout.
Note: is may
require 4 inches of
clearance.
■ Apply pipe sealant
on both ex hose
adapters. read
into side of tee.
■ Attach ex hoses to
ex hose adapters.
■ Plumb hot water
supply to le valve
body inlet, cold
water to right inlet
(supply hoses not
included).
■ Check for leaks
if only replacing
faucet and drain is
already installed by rst turning faucet handles to the OFF
position and then turn water supply valves ON.
Step 5 Fasten drain body to sink
■ Remove stopper, unscrew
ange and remove at
rubber washer from end
of drain body as shipped.
■ Apply plumber’s putty
around bottom of ange.
Note: Rubber washer
included should only be
used when plumbers
putty is not available.
■ Move friction washer,
beveled washer and
ange nut down away
from threaded end of
drain body.
■ Place ange into drain
opening and then from
under sink screw drain
body up into ange at least
2-3 turns until hand tight.
■ Position drain body so pivot cavity is facing rear of sink and
then slide beveled washer and friction washer up against sink.
■ Tighten ange nut up against friction washer to evenly
compress beveled washer while also ensuring ange is
centered in drain opening.
Take care not to over tighten ange nut.
PLUMBERS
PUTTY
ange
beveled
washer
friction
washer
pivot
cavity
ange nut
drain body
Pipe
Sealant
ex hose
spout
valve
outlet
& inlet
ex hose
adapter
tee
valve
body