Installation Guide

ManualsBrandsSymmons ManualsBathroom Sink FaucetsUnity Satin Nickel 2-Handle Widespread WaterSense Bathroom Sink Faucet with Drain

Non-

Removable Removable

stopper stopper

Quick Install Guide Allura Widespread Lavatory Faucet, S-244-2-LAM-RP

Flush water supply lines

Step 10

Step 1

Attach faucet spout

Step 3

Attach faucet handles

Step 2

Attach pivot rod to drain body

Step 7

Connect lift rod, clevis strap,

pivot rod and adjust linkage

Step 8

Install stopper and

set eye position

Step 6

Attach drain body to drain trap

Step 9

Step 4

SConnect water supply lines

Attach control valves to sink

Step 1

Fasten drain body and

tail piece to sink

Step 5

PLUMBERS

PUTTY

Sealer

Model Numbers

Tools & Materials

Installation and Service Instructions

Allu ra

Widespread Lavatory Faucet S-244-2-LAM-RP

 Need Help?

Symmons customer service:

Phone: (800) 796-6667

gethelp@symmons.com

Mon - Fri 8:00 am - 7:30 pm EST



www.symmons.com/service

• Technical help

• Product information

• Warranty policy.

S-244-2-LAM-RP

Faucet and pop-up drain assembly with

chrome nish

S-244-2-LAM-XXX-RP

Faucet and pop-up drain assembly

Note: xxx in model number identies

location of alternate nish code when

applicable.

Summary of content (8 pages)

PAGE 1
Allura Widespread Lavatory Faucet S-244-2-LAM-RP Installation and Service Instructions  Need Help? Tools & Materials Model Numbers Symmons customer service: Phone: (800) 796-6667 gethelp@symmons.com Mon - Fri 8:00 am - 7:30 pm EST S-244-2-LAM-RP Faucet and pop-up drain assembly with chrome finish S-244-2-LAM-XXX-RP* Faucet and pop-up drain assembly *Note: xxx in model number identifies location of alternate finish code when applicable. Se r ale PLUMBERS PUTTY  www.symmons.
PAGE 2
Installation Instructions Caution: If replacing an older faucet ensure water supply is turned OFF before removing. Then open faucet valves to relieve water pressure. Step 1 Attach control valves to sink ■■ Thread flange nut about 2 inches down away from end of valve body. ■■ Insert valve body from under sink up through mounting hole. Ensure valve with red striped hose (hot) is on the left and blue (cold) is on the right.
PAGE 3
Step 5 Install stopper and set eye position Stopper can be removable or non-removable determined by position of eye hole when inserting pivot rod. ■■ Insert stopper through flange opening and rotate to position eye hole. stopper flange removable non removable Removing stopper When installed in the removable position, move pivot rod to the up position (lift rod is in the down position when later installed). Eye hole will slide over end of pivot rod.
PAGE 4
Dimensions Allura Lavatory Widespread Faucet, S-244-2-LAM-RP 8" (203 mm) min. 16" (406 mm) max. 4" (102 mm) min. 2" (51 mm) dia. 4-1/4" 108 mm 2-1/4" (57 mm) 3" 2-3/16" 76 mm 55 mm Deck thickness 1-3/8" (35 mm) max. 1-7/8" 47 mm 1-7/8" (47 mm) 1" dia. (25 mm) Hole size 1-1/16" (27 mm) min. 1-7/16" (37 mm) max. 13/16" dia (21 mm) Hole size 1-1/8" (29 mm) min. 1-1/2" (38 mm) max.
PAGE 5
Allura Grifo de Lavabo Widespread S-244-2-LAM-RP Instrucciones de instalación y mantenimiento Herramientas y los materiales Número de los modelos  ¿Necesita ayuda? Servicio al cliente de Symmons: P: (800) 796-6667 gethelp@symmons.
PAGE 6
Instrucciones de instalación Precaución: si reemplaza el grifo anterior, asegúrese de que el suministro de agua esté APAGADO antes de quitarlo. Después, abra las válvulas del grifo para liberar la presión de agua. Paso 1 Sujete las válvulas de control al lavamanos ■■ Enrosque hacia abajo la tuerca con brida collarín aproximadamente a 2 sujetador pulgadas (5 cm) desde el junta extremo del cuerpo de la válvula.
PAGE 7
Paso 6 Instale el obturador y establezca su posición El obturador puede obturador ser desmontable o no brida desmontable, lo cual se determina según la posición no del orificio del ojal cuando desmontable desmontable se inserta la varilla de pivote. Paso 9 Sujete el tubo de drenaje a la rejilla de drenaje Paso 10 ■■ Inserte el obturador a través de la abertura de la brida y gire para posicionar el orificio del ojal.
PAGE 8
Dimensiones Grifo de Lavabo Allura Widespread, S-244-2-LAM-RP 4" (102 mm) min. 8" (203 mm) min. 16" (406 mm) max. 2" (51 mm) dia. 4-1/4" 108 mm 2-1/4" (57 mm) 3" 2-3/16" 76 mm 55 mm Grosor de la cubierta 1-3/8" (35 mm) max. 1-7/8" 47 mm 1-7/8" (47 mm) 13/16" dia (21 mm) Tamaño del orificio 1-1/8" (29 mm) min. 1-1/2" (38 mm) max. 1" dia. (25 mm) Tamaño del orificio 1-1/16" (27 mm) min. 1-7/16" (37 mm) max.