Installation Guide

Caution: If replacing an older faucet ensure water supply is
turned OFF before removing. en turn faucet control valves
ON to relieve water pressure.
Step 1 Attach control valves to sink
■ read ange nut about 2 inches down from threaded end
of valve body.
■ Insert valve body from
underneath sink up
through mounting hole.
Ensure valve with red
striped hose (hot) is on
the le and blue (cold) is
on the right.
■ Place gasket over
valve body and
thread fastener
onto valve body
until stop is reached.
■ Tighten ange nut and
mounting washer under sink and secure with mounting
screws if necessary.
■ read collar onto outer threads of fastener until against
surface of sink.
Step 2 Attach faucet handles
■ Turn valve spindles
to the OFF position.
HOT - le valve, clockwise
COLD - right valve,
counter clockwise
■ Attach handle to valve
spindle in OFF location
and tighten screw through
handle into valve spindle.
Step 3 Attach faucet
spout to sink
■ Unscrew tee and remove washer and
nut from threaded end
of spout as shipped.
■ Insert end of spout
through base and
mounting hole.
Fasten from under sink
with washer and nut.
■ Tighten nut while
ensuring spout and
base are centered
over mounting hole
and at edge of washer
is facing rear of sink.
Step 4 Connect water supply lines
■ read tee onto
end of spout.
Note: is may
require 4 inches of
clearance.
■ Apply pipe sealant
on both ex hose
adapters. read
into side of tee.
■ Attach ex hoses to
ex hose adapters.
■ Plumb hot water
supply to le valve
body inlet, cold
water to right inlet
(supply hoses not
included).
■ Check for leaks if only replacing faucet and drain is already
installed by rst turning faucet handles to the OFF position
and then turn water supply valves ON.
Step 5 Fasten drain body to sink
■ Remove stopper, unscrew ange and remove at rubber
washer from end of drain body as shipped.
■ Apply plumber’s putty around bottom of ange.
■ Move friction washer,
beveled washer and
ange nut down away
from end of drain body.
■ Place ange into
drain opening and
screw drain body at
least 2-3 turns until
hand tight against ange.
Apply putty or teon
tape to tail piece and
attach to drain body.
■ Position drain body so
pivot cavity is facing rear
of sink and then slide
beveled washer and
friction washer up against
sink.
■ Tighten ange nut up
against friction washer
to evenly compress
beveled washer while also
ensuring ange is centered in drain opening.
Take care not to over tighten ange nut.
screw
handle
valve spindle
Pipe
Sealant
ex hose
spout
valve
outlet
& inlet
ex hose
adapter
tee
valve
body
spout
base
washer
nut
tee
collar
fastener
gasket
valve body
mounting washer
ange nut
mounting screws
PLUMBERS
PUTTY
ange
beveled
washer
friction
washer
pivot
cavity
ange nut
drain body
tail piece
Installation Instructions
Page 2