Installation Guide

Caution: If replacing an older faucet ensure water supply is
turned OFF before removing. en turn faucet control valves
ON to relieve water pressure.
Step 1 Attach control valves to sink
■ read ange nut about 2 inches down from threaded end
of valve body. Ensure larger diameter end is facing up.
■ Insert valve body from
underneath sink up
through mounting
hole. Ensure valve
with red label (hot)
is on the le and blue
(cold) is on the right.
■ Place gasket over
valve body and
thread fastener
onto valve body
until stop is reached.
■ Tighten ange nut under sink to secure valve body.
■ read collar onto outer threads of fastener until against
surface of sink.
Step 2 Attach faucet handles
■ Turn valve spindles
to the OFF position.
HOT - le valve,
clockwise
COLD - right valve,
counter clockwise
■ Attach handle to
valve spindle in OFF
location and tighten
screw through
handle into valve
spindle.
Step 3 Attach faucet spout to sink
■ Unscrew tee and remove washer and
nut from threaded end
of spout as shipped.
■ Insert end of spout
through base and
mounting hole.
Fasten from under sink
with washer and nut.
■ Tighten nut while
ensuring spout and
base are centered
over mounting hole
and at edge of washer
is facing rear of sink.
Step 4 Connect water supply lines
■ Apply pipe sealant
on male end of
both ex hoses
and thread into
sides of tee.
■ read center of
tee with ex hoses
attached onto
end of spout.
Note: is may
require about
4 inches of
clearance to rotate.
■ Attach loose end
of ex hoses
to valve outlets.
■ Plumb hot water
supply to le valve
inlet, cold water
to right inlet and
fasten with coupling nuts.
■ Check for leaks if only replacing faucet and drain is already
installed by rst turning faucet handles to the OFF position
and then turn water supply valves ON.
Step 5 Fasten drain body to sink
■ Remove stopper, unscrew
ange and remove at
rubber washer from end
of drain body as shipped.
■ Apply plumber’s putty
around bottom of ange.
■ Move friction washer,
beveled washer and
ange nut down away
from end of drain body.
■ Place ange into
drain opening and
screw drain body at
least 2-3 turns until
hand tight against ange.
Apply putty or teon
tape to tail piece and
attach to drain body.
■ Position drain body so
pivot cavity is facing rear
of sink and then slide
beveled washer and friction washer up against sink.
■ Tighten ange nut up against friction washer to evenly
compress beveled washer while also ensuring ange is
centered in drain opening.
Take care not to over tighten ange nut.
screw
handle
valve spindle
Pipe
Sealant
spout
base
washer
nut
tee
collar
fastener
gasket
flange nut
valve body
PLUMBERS
PUTTY
ange
beveled
washer
friction
washer
pivot
cavity
ange nut
drain body
tail piece
Installation Instructions
Page 2