Installation Guide

Page 3
Valve cartridge replacement
fasten to end of
clevis strap in the
up position and
stopper is in the
closed position.
Insert ■ li rod into
end of clevis strap
and fasten with
thumb screw at
location where
stopper can be
easily opened and
closed.
If necessary, select
another location
hole in clevis strap
and re-adjust li
rod where fastened to clevis strap to ensure easy operation.
Step 7 Attach drain body to drain trap
Step 8 Flush water supply lines
 oroughly  ush supply
lines to prevent foreign
matter, i.e. copper chips,
sand, etc. from damaging
the sealing surface inside
control valves.
Remove ■ aerator from
end of faucet spout
by rotating counter
clockwise
Turn hot and cold ■
faucet handles to full ON position and then open water
sup ply valves long enough to  ush supply lines thor ough ly.
Turn faucet ■ OFF, replace aerator and check for any leaks.
Care of faucet fi nish
Clean  nish area by using mild soap and water or non-abrasive
cleaners and then rinse immediately. A non-abrasive wax may
be used to preserve  nish area.
remove
aerator
2-9/16"
65 mm
2"
51 mm
4"
102 mm
6"
152 mm
4-1/2"
114 mm
1-3/8" max.
35 mm
1/2"-14 NPSM
Hole diameter
1" (25 mm)
2-1/8"
54 mm
4-1/4"
108 mm
4-1/4"
108 mm
3-3/8"
79 mm
2-1/4"
57 mm
Dimensions Allura Lavatory Faucet, S-240 Series
Nt
Valve cartridge replacement
1
2
COLD water
cartridge identified
by grooves
3
clevis strap
lift rod
small plug
thumb
screw
location
hole
spring clip
pivot rod