Installation Guide

Installation Instructions
Page 2
Caution: If replacing an older faucet ensure water supply is
turned
OFF before removing.  en turn faucet control valves
ON to relieve water pressure.
Step 1 Attach faucet to sink
Insert threaded ■
water inlets
through gasket
and mounting
holes.
 read ■  ange
nut along
supply inlet
under sink.
Ensure larger
diameter end
is facing up toward faucet.
Hand tighten ■  ange nuts while also ensuring faucet
and gasket are centered over mounting holes.
Ensure not to over tighten with pliers.
Step 2 Connect water supply lines
Plumb hot water ■
supply to le inlet
and cold water to
right inlet as viewed
from front of faucet.
Connect ■ supply
line to supply inlet
with coupling nut
and tighten.
Check for leaks ■
if only replacing
faucet and drain is
already installed by  rst turning faucet handles to the OFF
position and then turn water supply valves ON.
Step 3 Fasten drain body to sink
Remove ■ stopper,
unscrew  ange and
remove washer from
end of drain body as
shipped.
Apply plumber’s ■
putty around
bottom of  ange.
* Note: Washer included
should only be used
when plumbers putty is
not available.
Move ■ friction washer,
beveled washer and
 ange nut down away
from end of drain body.
supply
inlet
gasket
ange
nuts
supply Inlet
coupling nut
supply line
PLUMBERS
PUTTY
ange
washer *
(optional)
Place ■  ange into
drain opening and
from under sink
screw drain body up
into  ange at least 2-3
turns until hand tight.
Position ■ drain body so
pivot cavity is facing
rear of sink and then
slide rubber beveled
washer and friction
washer up against
sink.
Tighten ■  ange nut up
against friction washer to evenly compress beveled washer
while also ensuring  ange is centered in drain opening.
Take care not to over tighten  ange nut.
Step 4 Install stopper and set eye position
Stopper can be removable or non-removable determined by
position of eye hole when inserting pivot rod.
Insert ■ stopper
through  ange
opening and
position eye hole.
Removing stopper
When installed in the
removable position,
move pivit rod to the
up position
(li rod is in the down position when later installed).
Eye hole will slide over end of pivot rod.
Step 5 Attach pivot rod to drain body
Remove ■ retaining
nut and outer seat
from pivot cavity.
Insert ■ pivot rod
into pivot cavity
so ball is against
inner seat and
rod passes under
stopper according
to selected eye
hole position.
Insert ■ outer seat
over pivot rod with curved end against pivot ball.
Fasten ■ pivot rod to drain body with retaining nut. Tighten
until ball is seated snug and pivot rod can move freely.
Step 6 Connect lift rod and adjust linkage
Remove ■ small plug on back of faucet and insert li rod.
Fasten end of ■ pivot rod with spring clip through location
hole in clevis strap that is best aligned to enable li rod also
stopper
ange
non
removable removable
ange
beveled
washer
friction
washer
pivot
cavity
ange nut
drain
body
pivot rod
retaining nut
outer seat
pivot ball
inner seat
pivot cavity