Installation Sheet

Caution: If replacing an older faucet ensure water supply
is turned OFF before removing. en open faucet valves to
relieve water pressure.
Step 1 Attach faucet to sink
Screw short ■
threaded end of
mounting bolt
into bottom of
faucet until stop
is reached.
Insert ■ faucet,
bolts, and ex
hoses through
center of base and
mounting hole.
Slide ■ gasket and
washer over bolts
under sink and
fasten with hex nuts.
Center ■ faucet in sink mounting hole and tighten hex nuts.
Step 2 Connect water supply lines
Plumb hot water supply ■
to ex hose supply inlet
on le identied with
a red marker and cold
water to right hose
identied with green
or blue marker.
Fasten to ■ 3/8 inch
compression tting on
end of ex hose supply
inlet and tighten.
Check for leaks if only ■
replacing faucet and
drain is already installed by rst turning faucet handle to
the OFF position and then turn water supply valves ON.
Step 3 Fasten drain body to sink
Remove ■ stopper, unscrew
ange and remove
washer from end of
drain body as shipped.
Apply plumber’s putty ■
around bottom of ange.
Note: Washer included
should only be used
when plumbers putty
is not available.
Move ■ friction washer,
beveled washer and
ange nut down away
from end of drain body.
faucet
base
gasket
washer
hex nut
ex hose
bolt
ex hose
supply inlets
hot (red)
cold (green)
Place ■ ange in drain
opening and under
sink screw drain
body up into ange
at least 2-3 turns
until hand tight.
Position ■ drain body
so pivot cavity is
facing rear of sink
and then slide beveled
washer and friction
washer up against sink.
Tighten ■ ange nut up
against friction washer to evenly compress beveled washer
while also ensuring ange is centered in drain opening.
Take care not to over tighten ange nut.
Step 4 Install stopper and set eye position
Stopper can be installed
to be removable
or non-removable
determined by
position of eye hole
when inserting
pivot rod.
Insert ■ stopper
through ange
and rotate to
position eye hole.
Removing stopper
When set in removable position, move pivot rod to the up
position (li rod will be in the down position when later
installed). Eye hole will slide over end of pivot rod.
Step 5 Attach pivot rod to drain body
Remove ■ retaining nut
and outer seat from
pivot cavity.
Insert ■ pivot rod into
pivot cavity so ball
is against inner seat
and rod passes under
stopper according
to selected eye hole
position.
Insert ■ outer seat over
pivot rod with curved edge against pivot ball.
Fasten ■ pivot rod to drain body with retaining nut. Tighten
until ball is seated snug and pivot rod can move freely.
Step 6 Connect lift rod and adjust linkage
Insert li rod through hole on rear of water spout. ■
Fasten end of ■ pivot rod with spring clip through location
hole in clevis strap that is best aligned to enable li rod also
stopper
ange
non
removable removable
pivot rod
retaining nut
outer seat
pivot ball
inner seat
pivot cavity
PLUMBERS
PUTTY
ange
washer *
(optional)
ange
beveled
washer
friction
washer
pivot
cavity
ange nut
drain
body
Installation Instructions
Page 2