Installation Guide

ManualsBrandsSymmons ManualsPlumbingOxford 1-Handle Wall-Mounted Shower Trim Kit in Polished Chrome (Valve Not Included)

1

2

3

Oxford

®

Model Numbers

Oxford Trim Series

Oxford Trim Series with TA-10 Flow Control Spindle & T-12A Cap Assembly

Installation & Operation Instructions

TRIM ONLY

4200-TRM

Shower Valve Trim

4201-TRM

Shower Trim

4202-TRM

Tub/Shower Trim

4203-TRM

Hand Shower Trim

4205-TRM

Shower/Hand Shower Trim

4206-TRM

Tub/Shower/Hand Shower Trim

Compliance

• ASME A112.18.1/CSA B125.1

Limited Lifetime - to the original end purchaser in consumer/residential installations.

5 Years - for industrial/commercial installations.

Refer to www.symmons.com/warranty for complete warranty information.

Go to www.symmons.com/register to register your Symmons product.

TRIM, TA-10, T-12A

4200TRMTC

Shower Valve Trim

4201TRMTC

Shower Trim

4202TRMTC

Tub/Shower Trim

4203TRMTC

Hand Shower Trim

4205TRMTC

Shower/Hand Shower Trim

4206TRMTC

Tub/Shower/Hand Shower Trim

Warranty

4200-TRM

4200TRMTC

4201-TRM

4201TRMTC

4202-TRM

4202TRMTC

4205-TRM

4205TRMTC

4203-TRM

4203TRMTC

4206-TRM

4206TRMTC

TA-10T-12A

Summary of content (4 pages)

PAGE 1
Oxford® Oxford Trim Series Oxford Trim Series with TA-10 Flow Control Spindle & T-12A Cap Assembly Installation & Operation Instructions Model Numbers TRIM ONLY TRIM, TA-10, T-12A 4200-TRM Shower Valve Trim 4200TRMTC Shower Valve Trim 4201-TRM Shower Trim 4201TRMTC Shower Trim 4202-TRM Tub/Shower Trim 4202TRMTC Tub/Shower Trim 4203-TRM Hand Shower Trim 4203TRMTC Hand Shower Trim 4205-TRM Shower/Hand Shower Trim 4205TRMTC Shower/Hand Shower Trim 4206-TRM Tub/Shower/Hand Shower Trim 4206TRMTC Tub
PAGE 2
1. Recommended Tools FIGURE 1 Adjustable Wrench Allen Wrench (3mm) Drill Phillips Screwdriver Safety Glasses Thread Seal Tape 2. Dimensions A C B Measurements FIGURE 2 A B C D D E F G H I J K L F E J M N O P Q G I H R S N O M L K R P Q S Floor Notes: 1) Valve body and piping not included and shown as reference only. 2) Plaster shield (p/n T-176) for dry wall, plaster or other type walls 1/2" or greater. 3) All dimensions measured from nominal rough-in (see R as reference).
PAGE 3
. Parts Breakdown (Model Numbers Ending in TRMTC) LIMIT STOP SCREW Item 2 1 Cap Assy. T-12A 2 Flow Control Spindle TA-10 IMPORTANT: Model numbers ending in TRMTC coordinate with Temptrol pressure balancing valves ordered with Test Cap. The Test Cap is used to allow pressurization of system. Do not remove test cap from valve during wall construction, installation of valve or pressurization of system.
PAGE 4
7.