Specification

4
Installation (Drywall & Wall Stud with Mounting Anchor)
1) Place Toilet Paper Holder at desired
position. Mark the centers on each
end with a pencil. Follow steps 1-3
for wall and wall studs (page 3) to
install bracket to wall stud.
2) Use drill with 1" drill bit to drill holes
into drywall at the marked position.
3) Hold white ange upright and insert
mounting anchor bar into drywall
hole with the arrow facing toward
the drywall.
4) Pull backward on white ange so
bar straightens and tilts upright.
Arrow on bar must be facing
upwards for anchor to perform as
intended.
5) Keep pressure on bar behind the
drywall. Align holes in bar, white
ange and bracket. Align machine
screw with holes. Hand tighten
machine screw so bar remains
upright.
6) Tighten machine screw with phillips
head screwdriver so bracket
attached to mounting anchor bar is
ush with drywall.
Note: Hooks on bar will penetrate
drywall to help secure bar in the
upright position.
Note: The UP arrow on the bracket
must be facing installer and
pointing upright.
7) Attach ends of Toilet Paper Holder
to mounting brackets.
8) Secure Toilet Paper Holder end with
set screw. Repeat step for opposite
end.
9) Apply a bead of silicone around
the perimeter of the Toilet Paper
Holder ends to prevent water from
bleeding through the mounting holes
and potentially damaging the wall
and wall studs.