User Manual
Table Of Contents
- Introduction
- Parts of the WSS 1000 System
- Installing and Charging the Battery
- Assembling the WSS 1000 System
- Power
- Communicating with the Host
- Data Entry
- Removing the WWC 1000 from the Mount
- Cleaning
- Introduction
- Composants du système WSS 1000
- Mise en place et charge de la batterie
- Montage du système WSS 1000
- Alimentation
- Communication avec l’ordinateur central
- Saisie des données
- Retrait du WWC 1000 du dispositif de fixation
- Nettoyage
- Einführung
- Teile des WSS 1000-Systems
- Einsetzen und Laden des Akkus
- Montage des WSS 1000 Systems
- Strom
- Kommunikation mit dem Host
- Dateneingabe
- Herausnehmen des WWC 1000 aus der Montagevorrichtung
- Reinigung
- Introduzione
- Componenti del sistema WSS 1000
- Installazione e caricamento della batteria
- Assemblaggio del sistema WSS 1000
- Alimentazione
- Comunicazione con l’host
- Immissione dati
- Rimozione del WWC 1000 dal supporto
- Pulizia
- Introducción
- Partes del sistema WSS 1000
- Instalación y carga de la batería
- Ensamblaje del sistema WSS 1000
- Alimentación
- Comunicación con el ordenador central
- Registro de datos
- Extracción del WWC 1000 del montaje
- Limpieza
- Ergonomic Recommendations
- Regulatory Information
- Patent Information
Quick Reference
73
Regulatory Information
Radio Frequency Interference Requirements
This device has been tested and found to comply with the limits for a Class
B digital device pursuant to Part 15 of the Federal Communications
Commissions Rules and Regulation. These limits are designed to provide
reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
However, there is no guarantee that interference will not occur in a
particular installation. If the equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Re-orient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with FCC Part 15. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference and (2)
this device must accept any interference received, including interference that
may cause undesired operation.
Radio Frequency Interference Requirements -
Canada
This device complies with RSS 210 of Industry & Science Canada.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This Class B digital apparatus complies with Industry Canada Standard
ICES-003.
Cet appareil numérique de la classe B est conform à la norme NMB-003
d’Industrie Canada.