User's Manual

5
FINAL.Not for distribution.
Installation Instructions
The AP 300 mounts either on a wall with wide-shouldered screws
included or on a suspended ceiling T-bar.
Before Beginning
Perform the following:
• Match the model number on the purchase order with the model
numbers in the packing list and on the case of the device shipped.
• Verify that the contents of the box include the intended AP 300 and
the mounting hardware:
• Review site survey and network analysis reports to determine the
location and mounting position for the AP 300.
Wall Mounting
In the procedure below, hang the AP 300 Access Port along its length or
width using the slots on the bottom of the unit.
Hardware
• A CAT-5 cable connected to a compatible Symbol wireless
switch—for example, the WS 2000 or WS 5000—with sufficient
slack and without a molded or integrated strain relief on the
connector to the AP 300
• Two wide-shoulder Phillips pan head self-tapping screws
(provided)
• Case: In the procedure, use the arrows on the back of the AP
300’s case as a guide to determine the proper placement for the
unit’s mounting screws.
• Safety cable (recommended)
• Security cable (optional)
Procedure
1. Orient the case on the wall by its length or width.
Item Notes
WSAP-5030-300-WW 802.11a/b/g configuration.
Mounting Hardware: Two wide-shoulder Phillips
pan head self-tapping screws.