User's Manual

5
FINAL.Not for distribution.
802.11a Activity LED Amber
802.11b/g Activity LED Green
Installation Instructions
The AP 300 mounts either on a wall with wide-shouldered screws
included or in the ceiling.
Before Beginning
Perform the following:
Match the model number on the purchase order with the model
numbers in the packing list and on the case of the device shipped.
Verify that the contents of the box include the intended AP 300 and
the mounting hardware:
Review site survey and network analysis reports to determine the
location and mounting position for the AP 300.
Booting The amber LED flashes three times per second until firmware is
loaded. During boot, no 802.11a mobiles can associate.
Normal After adoption, the amber LED is steady or flashes with 802.11a radio
traffic.
Error The amber LED flashes once per second if an error prevents the
802.11a radio from operating normally.
Booting The green LED flashes three times per second until firmware is
loaded. During boot, no 802.11b/g mobiles can associate.
Normal After adoption, the green LED is steady or flashes with 802.11b/g
radio traffic.
Error The green LED flashes once per second if an error prevents the
802.11b/g radio from operating normally.
Item Notes
WSAP-5030-300-WW 802.11a and 802.11g configurations with external
RSMA (.11a radio) and RBNC (.11g radio) antenna
connectors. The antenna is a separate
purchasable item.
Mounting Hardware: Two wide-shoulder Phillips
pan head self-tapping screws.