Quick Reference Guide

5
Quick Reference
The terminal restarts and you can log in to an application. If you
have problems opening an application after resetting the terminal,
contact your System Administrator.
Note: If you reset a terminal, you may lose any unsaved data.
Entering Data
You can enter data into a
VRC 6940 terminal by
using the keyboard or an
attached scanner.
Tips for Using the Keyboard
• Press only one key at a time. Pressing two or more keys at
the same time can cause an error.
• Press the keys in correct sequence. When key sequences
are listed for an application, press the keys one at a time in
the order they are listed.
• Auto-repeat feature. Some applications use the auto-re-
peat feature of the keyboard. If they do, when you press and
hold a key, the key will repeat until you release it.
• Application functions. The keyboard may have different
functions depending on the application you are using. Refer
to your application documentation for more information.
Attaching a Scanner
1. Press the ON/OFF key to suspend the terminal.
2. Fit the scanner cable into the Scanner Connector on the rear
of the terminal.