Quick Reference Guide

14
VRC 6940 Terminal
To prepare the end of the External DC power cable:
a. In-line fuse holder: if no fused output is available,
add a fuse-holder and 5 Amp fuse to the External DC
power cable:
i. Strip back six inches of the cable jacket.
ii. Cut about 5” from the red power wire and strip 3/8” in-
sulation from the wire.
iii. Strip 3/8” insulation from the fuse-holder wire.
iv. Twist the stripped wire ends together and splice them
using a twist-on nylon wire connector.
v. Make sure the fuse holder contains a 5 Amp slow-
blow fuse. Wrap the wires neatly, as necessary.
In-line fuse holder with
5A slow-blow fuse
Twist-on nylon
Red power wire
i.
ii.
iii.
iv.
v.
wire connector
Wrapped wires
and fuse holder