User's Manual
Table Of Contents
- Warranty
- Patents
- Introduction
- About This Guide
- Features
- Unpacking
- Optional Accessories
- Mounting Bracket Installation
- Installing the Desiccant Bags
- Installing the VC5090 in a Forklift
- Installing the VC5090 on a Wall or Desktop
- Installing the Optional Keyboard
- Powering the VC5090 On/Off
- Charging the Internal Backup Battery
- Calibrating the Touch Screen
- Controlling Screen Brightness
- Controlling Keyboard Backlight
- Resetting the Vehicle Computer
- Programmable Keys
- Connecting Accessories
- Maintenance
- Troubleshooting
- Regulatory Information
- Products Equipped with Bluetooth® Wireless Technology
- Country Approvals
- Health and Safety Recommendations
- FCC / EU RF Exposure Guidelines
- Power Supply
- Batteries
- Taiwan - Recycling
- Wireless Devices - Countries
- Radio Frequency Interference Requirements
- Radio Frequency Interference Requirements - Canada
- Marking and European Economic Area (EEA)
- Waste Electrical and Electronic Equipment (WEEE)
20 VC5090 Vehicle Computer
Powering the VC5090 On/Off
The Main Power switch provides power
to the VC5090. You should only use this
switch when removing power completely
from the device.
Use the Power button on the front panel
to place the VC5090 into Suspend mode
or wake the VC5090 from Suspend
mode.
Charging the Internal Backup Battery
When you receive your VC5090, leave the VC5090 powered on for 24
hours to fully charge the internal backup battery. Note that the VC5090
can charge the backup battery while in Suspend mode, but not if power
is removed.
The internal battery maintains the RAM memory for 72 hours when fully
charged. The data in the Flash memory or Flash file system is not
affected by the state of charge.
Calibrating the Touch Screen
The VC5090 prompts you to calibrate the touch screen when you first
power on the VC5090.
1. Carefully press and hold the stylus on the center of each target.
Repeat as the target moves around the screen.
2. Tap the screen to accept the settings when the calibration is complete.
Main Power Switch
Power Button