User's Manual
Table Of Contents
- Warranty
- Patents
- Introduction
- About This Guide
- Features
- Unpacking
- Optional Accessories
- Mounting Bracket Installation
- Installing the Desiccant Bags
- Installing the VC5090 in a Forklift
- Installing the VC5090 on a Wall or Desktop
- Installing the Optional Keyboard
- Powering the VC5090 On/Off
- Charging the Internal Backup Battery
- Calibrating the Touch Screen
- Controlling Screen Brightness
- Controlling Keyboard Backlight
- Resetting the Vehicle Computer
- Programmable Keys
- Connecting Accessories
- Maintenance
- Troubleshooting
- Regulatory Information
- Products Equipped with Bluetooth® Wireless Technology
- Country Approvals
- Health and Safety Recommendations
- FCC / EU RF Exposure Guidelines
- Power Supply
- Batteries
- Taiwan - Recycling
- Wireless Devices - Countries
- Radio Frequency Interference Requirements
- Radio Frequency Interference Requirements - Canada
- Marking and European Economic Area (EEA)
- Waste Electrical and Electronic Equipment (WEEE)
Quick Reference Guide 15
• All power wiring must use the supplied power cable.
• Fuse in positive rail = 20A
• Fuse in negative rail = 20A
• Fuse in switched positive = 1A
• Use a filtered supply if available on the forklift. Consult the forklift
manufacturer for details.
CAUTION Use extreme care when routing and securing this
cable from the vehicle computer to the vehicle
power source. Hazards associated with improper
wiring can be severe. To avoid unintentional contact
between the wire and any sharp edges, use proper
bushings and clamping where the cable passes
through openings. If the wire is subjected to sharp
surfaces and excess engine vibration, the wiring
harness insulation can wear away, causing a short
between the bare wire and chassis. This can start a
fire.
VC5090
FUSE - 20A
FUSE - 1A
Switch
FUSE - 20A
Chassis ground
Vehicle
Battery
Power Cable
25-71919-01
Yellow
Red
Green
Black
or