User's Manual
Table Of Contents
- Introduction
- About This Guide
- Parts of the SPT 1800
- Parts of the SPT 1800 (continued)
- Parts of the SPT 1800 (continued)
- Getting Started
- Installing the SIM Card (SPT 1834 Only)
- Installing the Battery
- Starting the SPT 1800
- Using the SPT 1800
- Resetting the SPT 1800
- Attaching the Handstrap
- Scanning 1-D Bar Codes
- Scanning PDF417 (2-D) Bar Codes
- Initiating a Network Connection
- Maintaining the SPT 1800
- Troubleshooting
- Ergonomic Recommendations
- Regulatory Information
- Battery Caution
25
Quick Reference
Class 1 Laser devices are not considered to be hazardous when used for their
intended purpose. The following statement is required to comply with US and
international regulations:
Caution: Use of controls, adjustments or performance of procedures other than those
specified herein may result in hazardous laser light exposure.
Class 2 laser scanners use a low power, visible light diode. As with any very bright
light source, such as the sun, the user should avoid staring directly into the light
beam. Momentary exposure to a Class 2 laser is not known to be harmful.
Battery Caution
Caution: Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type recommended by the manufacturer. Dis-
pose of used batteries according to the manufacturer's instructions.
Scanner Labeling
SPT 1800 SPT 1834