User's Manual
Table Of Contents
- Introduction
- About This Guide
- Parts of the SPT 1800
- Parts of the SPT 1800 (continued)
- Parts of the SPT 1800 (continued)
- Getting Started
- Installing the SIM Card (SPT 1834 Only)
- Installing the Battery
- Starting the SPT 1800
- Using the SPT 1800
- Resetting the SPT 1800
- Attaching the Handstrap
- Scanning 1-D Bar Codes
- Scanning PDF417 (2-D) Bar Codes
- Initiating a Network Connection
- Maintaining the SPT 1800
- Troubleshooting
- Ergonomic Recommendations
- Regulatory Information
- Battery Caution
6
SPT 1800 Series
Installing the Battery
1. Open the latches on the
battery cover and lift it
away from the SPT 1800.
2. Insert the lithium-ion (Li-
ion) battery into the battery
compartment, ensuring
that it snaps into place.
3. Replace the battery cover
and close the latches.
Note: Keep the battery
latches completely
open while securing
the battery cover.
Charging the Battery
Note: The SPT 1800 battery (p/n 20-36098-01) must be used
only with the SPT 1800.
Before using your SPT 1800 for the first time, charge the battery
using the cradle, the Synchronization/Charging Cable or the
Universal Battery Charger (UBC). For instructions on using the
UBC, see the
UBC Quick Reference Guide
.
Caution: The main battery charges the backup battery in the
SPT 1800. Once the battery is fully charged, do not re-
move it from the SPT 1800 for 24 hours. During this pe-
riod, the SPT 1800 cannot maintain any user data if the
battery is removed from the terminal.
Latch
Latch