User's Manual
Table Of Contents
- Introduction
- About This Guide
- Parts of the SPT 1800
- Parts of the SPT 1800 (continued)
- Parts of the SPT 1800 (continued)
- Getting Started
- Installing the SIM Card (SPT 1834 Only)
- Installing the Battery
- Starting the SPT 1800
- Using the SPT 1800
- Resetting the SPT 1800
- Attaching the Handstrap
- Scanning 1-D Bar Codes
- Scanning PDF417 (2-D) Bar Codes
- Initiating a Network Connection
- Maintaining the SPT 1800
- Troubleshooting
- Ergonomic Recommendations
- Regulatory Information
- Battery Caution
13
Quick Reference
Note: With a hard reset, the current date and time are re-
tained. Formats, preferences and other settings are re-
stored to their factory default settings.
Attaching the Handstrap
The SPT 1800 has a handstrap which increases comfort when
holding it for extended periods of time.
To attach the handstrap for the SPT 1834:
1. Put the side slots of the thread-
ed button over the wire clips on
the handstrap.
2. Screw the button into the
threaded slot on the back of the
terminal.
3. Slide the flat metal piece into
the handstrap connection on
the bottom of the terminal.
1. Thread round metal piece
through this connector.
3. Adjust the velcro strap to fit your
hand.
2. Slide flat metal piece up and into
this connector.