User's Manual
Table Of Contents
- Introduction
- About This Guide
- Parts of the SPT 1800
- Parts of the SPT 1800 (continued)
- Parts of the SPT 1800 (continued)
- Getting Started
- Installing the SIM Card (SPT 1834 Only)
- Installing the Battery
- Starting the SPT 1800
- Using the SPT 1800
- Resetting the SPT 1800
- Attaching the Handstrap
- Scanning 1-D Bar Codes
- Scanning PDF417 (2-D) Bar Codes
- Initiating a Network Connection
- Maintaining the SPT 1800
- Troubleshooting
- Ergonomic Recommendations
- Regulatory Information
- Battery Caution
8
SPT 1800 Series
3. Plug the power cable into a wall outlet and plug the other end
into the battery charging receptacle on the side of the Syn-
chronization/Charging Cable.
The battery is fully charged after approximately two hours.
Starting the SPT 1800
Press the red power button to power on the terminal. If the terminal
does not power on, perform a hard reset. See
Performing a Hard
Reset
on page 12.
Calibrating the Screen
The first time you start your SPT 1800, the Welcome utility
appears. Follow the steps to align the internal circuitry of your SPT
1800 with its touch-sensitive screen, and to set the current time
and date.
Note: If your SPT 1800 unit came pre-loaded with a custom
software application, you may not need to calibrate
your screen, in which case you will not see the Wel-
come utility.
Battery
Charging
Receptacle
Power
Supply
Serial Cable